TITEBOND KITCHEN & BATH SEALANT


Titebond Kitchen & Bath Sealant is a non-reactive, high-performance, modified acrylic formula designed to permanently seal high-moisture areas found in kitchens and baths. This flexible sealant offers strong, watertight adhesion and is safe for food preparation areas when fully cured.

more

Features & Benefits

check_circle
IDEAL FOR: Sealing around tubs, showers, sinks and countertops.
check_circle
SEALS: Vinyl, ceramic tile, porcelain, plastic, painted surfaces, aluminum, glass, marble, brick, wood and most common building materials.
check_circle
For use on tubs, showers, sinks and countertops
check_circle
Resistant to dirt, water, stains and mildew
check_circle
Once cured, will not shrink or discolor over time
check_circle
Excellent flexibility & adhesion
check_circle
Permanently seals

Application Guidelines

Application Temperature:
Above 40°F (4°C)
Service Temperature Range:
0°F to 160°F (-17°C to 71°C)
Method of Application:
Cartridge/caulking gun
Working Time:
Approximately 15 minutes for a 1/4" bead
Application Directions:
1. Surfaces must be clean and free of any material that may prevent adequate adhesion. Properly designed joint not to exceed 1/2" in width. 2. Cut tip at 45° angle for 1/8" to 1/2" bead and place in cartridge gun. 3. Force sealant into clean joint. If necessary, smooth bead immediately. It is the sole responsibility of the user to thoroughly test any proposed use with all substrates to determine project suitability.
Painting:
The sealant should be dry to the touch and ready to paint in 4-6 hours.
Cleanup:
Clean uncured material with water. After curing, excess sealant must be cut or scraped away.
Coverage:
Container 1/8” Bead 1/4" Bead 3/8" Bead 1/2" Bead
10.1 oz. Cartridge 123 ft. 31 ft. 14 ft. 8 ft.
Limitations:
Not designed for continuous submersion or use below the waterline. Air, sealant and surface temperature should be above 40°F. Allow at least 24 hours before exposing to water. Cure time is dependent upon ambient conditions including temperature and humidity. The sealant should be dry to the touch and ready to paint in 4-6 hours. It is highly recommended to use backing material. For best results, store in a dry location at or below 75°F.

Physical Properties

Type
Modified Acrylic
Calculated VOC
<50 g/L (<1.5%)
Color
White and clear
Weight Per Gallon
11.23 lbs. white, 8.8 lbs. clear
Solids
72% white, 60% clear
Flashpoint
Solvent free/Not applicable
Freeze / Thaw Stability
Stable
Viscosity
250,000 cps
Storage Life
24 months in a dry location at or below 75°F

SPECIFICATIONS

White Exceeds:
  • ASTM C834 Type OP Grade 0°C
  • FDA 21-CFR-177.2600
Clear Exceeds:
  • ASTM C834 Type C Grade NF
  • FDA 21-CFR-177.2600

Warranty Statement

Liability is limited to product replacement only.